If you need to change matches you made for Brivo doors to WhosOnLocation Location Access Control Points (LACPs) during the wizard, or match any new doors, you can do so from this section.
- Go to Tools > Account.
- Select Integrations from the left-hand menu.
- Select the Brivo integration.
- Click Settings.
- Select Doors from the left-hand menu.
The number of unassigned doors (if any) will display in a red bubble next to the Doors option.
In this section, you can assign doors to their corresponding LACPs, allow doors to be opened by triggers, set if a door is signing a person in or out, and manually unlock a door for a short period.
To assign a door, click Assign, select an LACP, and click Assign. The LACP’s available will be based on the location that the door’s site has been matched to. You cannot unassign a door from this section, to unassign a door you need to re-run the setup wizard.
To allow a door to be opened by triggers, click Config, set 'Allow Trigger to open this door' to Yes, and click Save. This will not automatically create a trigger for the door, but it will allow you to set up a trigger to open this door in your corresponding location.
To set if a door, when used, is signing someone in or out, click Config and click 'Set Staff presence when accessing this door' to Onsite for sign in or Offsite for sign out. This will automatically change the status of a person who uses the door to the selected option in WhosOnLocation.
To manually unlock the door, click Unlock. This will unlock the door for the period set in Brivo.